POWER-ON MESSAGE

Each time you switch the transceiver ON, the factory-default message appears and stays for approximately 2 seconds. You can program your favorite message in place of “KENWOOD”.

1Press [MNU] to enter Menu mode.

2Select Menu No. 2 (Front Panel).

CALL

PWR

VOL SQL

3Press [s], then select Item No. 2 (Power On Msg).

CALL

PWR

VOL SQL

2

1

4Press [SET].

•The last digit blinks.

5Press [VFO].

•The cursor moves to the first digit.

6Turn the Tuning control, or press Mic [UP]/[DWN], to select the first digit.

•To skip by four characters when operating the above control or keys, press [MHz]. Press [MHz] again to quit this jump function.

7Press [s].

•The second digit blinks.

8Repeat steps 6 and 7 to enter up to 7 digits.

•After entering the 7th digit, pressing [s] causes an error beep to sound.

•To re-enter the preceding digit, press [t].

•To clear all digits and move back to the first digit, press [VFO].

9Press [SET] again to complete the setting.

10Press [MNU] to exit Menu mode.

DISPLAY DEMONSTRATION MODE

By initiating this mode, various pre-programmed displays appear. You still can normally use the transceiver in this mode. Pressing buttons or microphone keys, or turning the Tuning control restores the operating display immediately. If there is no button/key entry or Tuning control adjustment for approximately 12 seconds, the transceiver reverts back to Demonstration mode.

Press [F]+ POWER ON to toggle the mode ON or OFF.

1

2

3

4

5

6

7

8

9

10

11

12 13

14

15

16

17

18

19

20 21

69