PREPARATION FOR MOBILE AND FIXED STATION OPERATION

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

MOBILE INSTALLATION

Install the transceiver in a safe, convenient position inside your vehicle that minimizes danger to your passengers and yourself while the vehicle is in motion. For example, consider installing the transceiver under the dash in front of the passenger seat so that knees or legs will not strike the radio during sudden braking of your vehicle. Try to pick a well-ventilated location that is shielded from direct sunlight.

■ Installation Example

Use the supplied mounting bracket to install the transceiver inside your vehicle. To enjoy the best viewing angle, you can position the transceiver in the bracket in a number of ways as shown below.

 

M

 

M4×8MAX

4×8

MAX

 

M4×8MAX

■Installation Steps

1Install the mounting bracket in the vehicle using the supplied flat washers and self-tapping screws. There are 4 washers and 4 screws supplied.

•The bracket can be mounted with the bracket opening for the transceiver facing down for underdash mounting, or with the opening facing up.

•The bracket must be installed so that the 4 screw holes on the edge of each bracket side are facing forward.

Flat washer

Self-tapping screw

2Position the transceiver, then insert and tighten the supplied hexagon SEMS screws and washers. There are 2 screws and 2 washers supplied for each side of the bracket.

•Double check that all hardware is tightened to prevent vehicle vibration from loosening the bracket or transceiver.

K

 

 

EN

 

 

WO

 

 

OD

FM

 

 

DUAL

BANDER

 

 

TM-V7

SEMS screw

2