Kodak DC220, DC260 manual Turning the camera on, Entering the Capture mode

Turning the camera on

Ready light

1Press the POWER button.

The green Ready light on the back of the camera blinks for approximately 10 seconds until the camera is ready to take pictures and the Status Display on the top of the camera turns on.

To turn the camera off, press the POWER button again.

☞If the camera is turned off while a picture is being processed, the camera will finish processing the picture before turning off.

If your camera is idle for the time period you set in the Camera Properties Time- out Settings, it automatically turns off. To turn the camera on again, press the POWER button.

Entering the Capture mode

You will use the Capture Mode to take pictures. To place the camera in the Capture Mode:

1Turn the Mode dial to the CAPTURE setting.

The camera moves the lens to a point away from the camera.

☞You cannot take pictures without a memory card in the camera. If you enter the Capture mode without a memory card, the Status LCD flashes the message “NO CARD.”

If the camera goes into sleep mode to conserve power, the word “CARD” remains on the Status LCD.

3-2