Duplexing Not supportedGlossy Not supported

Mode

Use envelopes that are

„Common office envelopes approved for laser printing with diagonal joints, sharp folds and edges, and ordinary gummed flaps

" Because the envelopes pass through heated rollers, the gummed area on the flaps may seal. Using envelopes with emulsion-based glue avoids this problem.

„Approved for laser printing„DryDO NOT use envelopes that have„Sticky flaps

„Tape seals, metal clasps, paper clips, fasteners, or peel-off strips for seal- ing

„Transparent windows„Too rough of a surface„Material that will melt, vaporize, offset, discolor, or emit dangerous fumes„Been presealed

Labels

A sheet of labels consists of a face sheet (the printing surface), adhesive, and a carrier sheet:

„The face sheet must follow the plain paper specification.

„The face sheet surface must cover the entire carrier sheet, and no adhe- sive should come through on the surface.

You can print continuously with label sheets. However, this could affect the media feed, depending on the media quality and printing environment. If problems occur, stop the continuous printing and print one sheet at a time.

Try printing your data on a sheet of plain paper first to check placement. Check your application documentation for more information on printing labels.

Capacity

Tray 1

Up to 20 label sheets, depending on their

 

(Manual Feed

thickness

 

Tray)

 

 

Tray 2/3/4

Not supported

Orientation

Face down

 

102

Media Types