Connecting via a Straight-Through Cable | Kramer Electronics PL-150

Connecting the PL-50 Power Controller - Monitor

5.Select the Internet Protocol (TCP/IP) and click the Properties button (see Figure 6).

Figure 6: Local Area Connection Properties Window

6.Select Use the following IP address, and fill in the details as shown in Figure 7.

7.Click OK.

Figure 7: Internet Protocol (TCP/IP) Properties Window

6.2.2Connecting via a Straight-Through Cable

You can connect the ETHERNET of the PL-50to the Ethernet port on a network hub or network router, via a straight-through cable with RJ-45 connectors.

10	KRAMER: SIMPLE CREATIVE TECHNOLOGY

Image 14

Kramer Electronics PL-150 user manual Connecting via a Straight-Through Cable

Contents

Model Contents Figures Instruction Codes43 Tables P3K Wizard Software IntroductionGetting Started Quick Start Getting Started Overview Ethernet Your PL-50 Power Controller Monitor Your PL-50 Power Controller Monitor PL-50 Power Controller Monitor Front Panel PL-50 Power Controller Monitor Features Feature Function Installing in a Rack Before Installing in a Rack Connecting the PL-50 Power Controller Monitor Connecting the PL-50 Right-click Local Area Connection Properties Connecting the RelaysControlling the PL-50 via the Ethernet Port Local Area Connection Properties window appears Connecting via a Straight-Through Cable Click the Connect button Connect screen appears as follows Upload Main Screen If required, make changes and click Save. If not, click Exit Controlling via the Embedded Web Pages Following window appears Running the Application Panel Screen Scheduler Screen Features Scheduler Screen Help BOX Define the Channel Settings screen Channel Settings Screen Features Alerts Screen Features Define the Alerts screen Setting the Alarms Define the Power Measurement screen Power Measurement Screen Features Power ON/OFF Order Screen This page lets you set the power on and OFF order and delay Configurations Screen Enable Security System Security System Enabled Security System DIP-switch Definitions Operating Your PL-50 Power Controller MonitorDIP-switch Settings Calibrating via the Front Panel Buttons Operating Your PL-50 Power Controller Monitor Flash Memory Upgrade Upgrading the Firmware Click the Connect button Connect Window appears see Figure Upload Screen Machine is now connected Connection Time Out Message Upload Connected Upload Progress When the update is finished, the restart message appears Restart Message Technical Specifications1 of the PL-50 Technical SpecificationsIncludes the technical specifications Changing the Device Parameters Host message format Kramer ProtocolProtocol 3000 Syntax CR LF Command Terms Command Common Commands NAME? FactoryName NAME? Name Result and Error Codes Security Commands Network Setting Commands These commands are used by network devices running Protocol NET-GATE NET-DHCPNET-DHCP? NET-GATE? Instruction Codes ALARM-ON Result ALARM-ON? ALARM-OFFALARM-ON ALARM-START-AS LVL SwitchMES-MODE SCHED? SWITCH-ORDER-DELAY SWITCH?SWITCH-ORDER SWITCH-ORDER-DELAY? Limited Warranty 2900-000576 REV