Kramer Electronics PL-150 user manual Connecting the PL-50 Power Controller Monitor

Connecting the PL-50 Power Controller - Monitor

6 Connecting the PL-50 Power Controller - Monitor

To connect the PL-50, as illustrated in the example in Figure 4, do the following1:

1.Connect up to five2 outlets (from 1 to 5). For example, connect:

OUT 1 to a DVD player

OUT 2 to an LCD display

OUT 4 to a power amplifier with speakers

OUT 5 to a lighting system

2.Set the DIP-switches (see Table 2).

3.Connect an item (for example, an alarm) via the RELAY and/or DIGITAL CONTROL terminal block connectors (not shown in Figure 4).

4.As an option you can connect a PC and/or controller to the RS-232 port, RS-485 port and/or the ETHERNET connector (see section 6.2.1)

5.Connect the power cord3 (not shown in Figure 4).

Figure 4: Connecting the PL-50

1 Be sure that the power is switched OFF on each device before connecting it to your PL-50. After connecting all the devices to your PL-50, switch on the power of the PL-50, and then switch on the power of each device

2 You do not have to connect all the outlets. In this example OUT 3 is not connected

3 We recommend that you use only the power cord that is supplied with this machine

8 KRAMER: SIMPLE CREATIVE TECHNOLOGY