Operating Your PL-50 Power Controller – Monitor
To set the Standby mode1, do the following:
1.Press one or more OUT buttons to select the channels for which you want to measure the standby or active modes.
The selected buttons illuminate.
2.Set the connected units to the Standby mode
3.Press the PRESET LEVEL STANDBY button.
The selected orange OUT buttons, and their related STANDBY orange LEDs blink.
4.Press each of the selected orange blinking buttons to initialize the measurement.
The STANDBY orange LED blinks until measurement is complete.
To reset the active and standby values on all channels, press the RESET button on the rear panel while turning the power ON.
You can measure the Active and Standby values as well as reset individual channels via the embedded Web pages (see section 6.3.2).
1 The unit should be powered up and running under typical conditions when the measurements are made
28 | KRAMER: SIMPLE CREATIVE TECHNOLOGY |
