Kyocera FS-5900C manual Setting the Sleep Timer, Resource Protection, To set the sleep timer

Using the Printer

Setting the Sleep Timer

The sleep timer can be set anywhere from 0 to 120 minutes in 5-minute increments. Setting the sleep timer to 0 turns it off. The sleep timer is set at the factory to 60 minutes.

To set the sleep timer:

1	Press the MODE key on the printer panel.
2	Press the + key repeatedly until the message display indicates
	Others>.
3	Press the key.
4	Press the + key repeatedly until the message display indicates
	>Sleep timer.

The current sleep timer (in minutes) is indicated.

5

6

7

8

Press the ENTER key. The underline cursor flashes.

Press the + or - key to change the timer setting. You can use the or key to quickly change the timer setting.

Press the ENTER key to finalize the setting.

Press the MODE key to exit the mode selection menu.

Once the set time arrives, the printer will display Sleeping and all indicators will go out. This minimizes the amount of energy used.

Resource Protection

When you switch from the PCL 5C emulation to KPDL, all downloaded fonts and macros are lost. Resource protection preserves these PCL resources in memory so that they are intact when you change the emulation back to PCL 5C.

By using the printer’s >Resource prot.menu, you can select from two resource protection modes:

62