Kyocera FS-C8008DN, FS-C8008N manual Baud Rate, Range

3.5 Changing the Interface Parameters

Pressing the U or V key toggles through the serial parameters as follows. To change the serial parameter, press the ENTER key. Use the U or V key to change the value or selection.

>Baud Rate 9600

>Data Bits 8

>Stop Bits 1

>Parity None

>Protocol

DTR(pos.)&XON

Range

1200, 2400, 4800, 9600 (Default), 19200, 38400, 57600, 115200

7 or 8 (Default)

1 (Default) or 2

None (Default), Odd, Even, or Ignore

DTR(pos.)& Xon (Default), DTR(positive), DTR(negative), XON/XOFF, or ETX/ACK

For example, to change baud rate from 9600 to 115200, display the baud rate menu following the above procedure. When the display shows baud rate, 9600 (bps), press the ENTER key. A blinking question mark (?) appears.

>Baud Rate

?9600

Press the U or V key to scroll through values. When 115200 is displayed, press the ENTER key. Press the MODE key to exit the menu selection.

Some computers may not be able to handle a baud rate of 115200 bps. If you set the baud rate to 115200 and encounter communication problems, select a lower baud rate.

Note

3-36