INSTALLING THE UNIT

Note: The unit has an internal battery that will save the settings when unplugged.

The unit can be used on a table-top or mounted on a wall. When choosing a location, please note locations to avoid in "Environmental Conditions" at the bottom of the page. If you are using the unit as a table-top, find an appropriate place and skip to Step 3. If using as a wall-mount, take the following steps.

Mounting Unit on Wall

The unit can be mounted on a wall using the supplied mounting fittings.

1 Install wall mount screws (supplied) into a wall 3 15/16" (10 cm) apart.

Be sure to keep about 1/8" ( 3mm) of the screw head out of the wall.

(10cm) 315/16"

Use template on bottom of page 10 if you prefer.

The supplied screws are intended for use on a thick wooden wall or wooden column. Do not use them on any other materials. There is a danger that the unit may come off if used on other materials.

2 Mount the wall mount fittings as shown on the right.

3 Plug the unit into power, and the unit is ready to use.

(3mm)1/8"

Environmental Conditions

Avoid placing the unit in environments that are:

humid or dusty

exposed to direct sunshine

subject to frequent or continuous vibrations

outside the temperature range between 23˚F (-5˚C) and 113˚F (45˚C)

affected by chemicals or ozone

9

Page 12
Image 12
Lathem 7500E manual Mounting Unit on Wall, Environmental Conditions