Lennox Hearth II-T C INS Installation Check List, Check list, Prior to lighting your stove

INSTALLATION

INSTALLATION CHECK LIST

It is strongly recommended that you have an authorized Lennox Hearth Products dealer install your stove. If you install your stove yourself, you should review your instal- lation plan with an authorized Lennox Hearth Products dealer. Improper installation may void your warranty.

Check list:

Check off each item as you proceed with the installation process.

Read the ENTIRE stove installation section first Read the Insert or Freestanding section (whichever applies).

Determine the appropriate measurements and loca- tions for your installation.

Follow the general installation directions under Stove Installation and the installation section appropriate to your stove.

Be sure to pre-fit all items before you install, fasten, or set up the stove permanently.

Prior to lighting your stove:

Review the Important Warnings section (page 2). Review Fuel Specifications (page 25).

Review and follow instructions in the Care and Op- eration Section (pages 21 to 25).

Plug power cord connector into corresponding con- nector on the back of appliance (see illustrations on page 12 showing connector locations).

Note: Advantage II-T C INS – Route power cord be- hind side surround panel.

After you have begun operation of your stove:

Review the routine cleaning / maintenance informa- tion.

Enjoy the warmth from your new Lennox Hearth Products pellet stove!

Advantage II-T C Insert

It is important to level the appliance. In some installa- tions such as a recessed firebox floor (if the existing fire- place floor is lower than the hearth), install the 2 leveling bolts (3/8-16 x 3 1/2” long) into the 2 threaded holes at the rear base of the Advantage II-T C INS. Adjust bolts until appliance is level.

PAGE 10

www.PelletKing.com