INSTALLATION
INSTALLING SURROUND ASSEMBLY - Advantage
The surround kit (purchased separately) comes with a set of metal panels that enclose the fireplace opening when fitted together. Put the surround assembly together accord- ing to the following instructions (ref. see illustration below).
1.Remove panels from package.
2.Verify that you have all three panels and a package with “pop” rivets and #8
3.Set the stove on the hearth so that the rear of the stove is accessible to complete all pipe connections.
4.Verify that the hopper cover is all the way to the front and open as high as your fireplace opening will allow. Secure the hopper cover with at least two #8 screws on all three sides. Tip: Spreading the side panels slightly may be nec- essary to complete this step.
5.Place four rivets and your “pop” rivet tool beside the stove and line up the right side panel (with control door) with the holes in the side of the stove. (When the side panel is properly installed, the hinge flange will be to the rear of the stove.) Attach the panel to the stove with four “pop” rivets.
6.Secure the left side surround panel to the stove using the procedure described in step #5.
7.Before proceeding further, check pipe connections to en- sure that all joints are sealed with
8.The stove may now be pushed into the fireplace cavity to within 1 1/2” of the face of the fireplace.
9.Set the top surround panel in place over the two side pan- els. Carefully slide the panel downward into the “U” clips
attached to the back of the Advantage
10.Unwrap the control board carefully without touching any electrical components. Holding the sides of the control board, lower the bottom edge into the slot in the bottom of the control door opening Install the control board onto the right side panel (with door) us- ing the #8 hex head screw provided.
11.Connect the wiring harness from the Advantage
12.Check the Advantage
If using the optional gold surround trim, remove the trim from its packaging and place the piece with the two mi- tered ends along the top panel. Place the two remaining side pieces on the surround so that the mitered ends align. Cut the
In factory built and masonry fireplaces, a means must be provided to prevent room air passage to the chimney cavity of the fireplace. This may be accom- plished by sealing the damper area around the chim- ney liner or pipe.
Top Surround Panel
Left Hinged | Right Hinged |
Surround Panel | Surround Panel |
Optional Trim | Optional Trim |
PAGE 11
www.PelletKing.com