INSTALLATION
THERMOSTAT INSTALLATION:
NOTE: Always Disconnect Power Before Performing The Thermostat Installation.
A 24 volt wall thermostat and 20 feet of
Installation Steps:
1.Unplug stove power cord from the wall outlet.
2.Locate the thermostat terminal block on the back of the stove.
3.Loosen the two terminal screws on the terminal block and remove jumper.
4.Connect the two wires from your thermostat to the terminals (one per terminal). Ensure that the purple wires from the harness remain connected to the ter- minal block and tighten the terminal screws. Make sure the wires are firmly connected to the thermo- stat.
5.Plug in the stove and you are ready to operate with your thermostat!
IMPORTANT: IF THE WALL THERMOSTAT PRO- VIDED IS NOT USED, THE JUMPER IS REQUIRED FOR THE STOVE TO OPERATE
PAGE 12
Rear View of Advantage II-T C FS
Back of Stove
Thermostat
Terminal
Block
Thermostat Jumper
www.PelletKing.com