SPECIFICATIONS - Advantage II-T C FS
Flue Size
Width, Overall
Depth, Overall
Depth, Overall w / 3” tee
Height
Floor to Rear
Flue Center
Facing Back of Unit, outside edge on right to center of rear flue outlet
Floor to Rear
Outside Air Inlet
Facing Back of Unit outside edge on right to center of air inlet
Floor Protection
Requirements
Standard Features
Hopper Capacity
Burn time
Fuse, Control Board Fuse, Igniter
Heat Input (Max.)
Emissions
Ship Weight
Room Air Blower
Auger Motor
Exhaust Blower
Options
3” Standard
24 3/4”
25” (26" to flue outlet)
307/8”
313/8”
17 1/2”
515/16”
11"
131/2”
+6" Front & Sides
& up to * 6” for the Back
Fastfire Self Igniter Wall Thermostat (wire included)
70lbs.
♦15.5 - 54 hours
5Amp, 250 volt, 3AG *
6Amp, 250 VAC *
♦11,000 - 38,000 BTU / hr
♦2.3 gr / hr (varies w / size
and type of fuel) EPA Certified
225 lbs.
150 CFM;1.5 Amps,
3000 rpm
1 RPM; .55 Amps
95 CFM: .95 Amps,
3000 rpm
Log Set
Gold Trivet
SIDE VIEW ILLUSTRATION
30 7/8”
25”
24 3/4”
BACK VIEW ILLUSTRATION
24 3/4"
31 3/8"
5 15/16"
7 9/16"
13 1/2"
171/2"
11"
9"
Note: Dimensions shown are approximations only (+/- 1/4”)
+
♦Fuel delivery and burn times will vary depending on size and type of fuel used. Estimated heat in- put based on fuel value of 8400 BTU per lb. Fuses are rated as fast blow.
PAGE 31
www.PelletKing.com