IMPORTANT WARNINGS
CAUTION: Read this manual thoroughly before starting installation. For your safety, follow the installation, op- eration and maintenance instructions exactly without deviation. Failure to follow these instructions may result in a possible fire hazard and will void the warranty. If this appliance is not properly installed, a house fire may result. Contact local building or fire officials about requirements and installation inspection in your area.
1.DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE CONNECTED TO ANOTHER APPLIANCE.
2.Do not connect this appliance to air ducts or any air distribution system.
3.Do not install a flue damper in the exhaust venting system of this appliance.
4.Do not use class B venting intended for gas appli- ances as a chimney or connector pipe on a pellet fired appliance.
5.The minimum clearances must be maintained for all combustible surfaces and materials including; furniture, carpet, drapes, clothing, wood, papers, etc. Do not store firewood within this clearance space.
6.INSTALLATION DISCLAIMER - This stoves exhaust system works with negative combustion chamber pressure and a slightly positive chimney pressure. Therefore, it is imperative that the exhaust system be gas tight (air tight, sealed connection) and in- stalled correctly. Since Lennox Hearth Products has no control over the installation of your stove, Lennox Hearth Products grants no warranty, im- plied or stated for the installation or maintenance of your stove, and assumes no responsibility for any consequential damage(s).
7.Burning any kind of fuel consumes oxygen. If out- side air is not ducted to the appliance, ensure that there is an adequate source of fresh air available to the room where the appliance is installed.
8.The stove will not operate using natural draft, nor without a power source for the blower and fuel feeding systems.
9.Never use gasoline,
10.CONTINUOUS OPERATION: When operated cor- rectly, this appliance cannot be overfired. Con- tinuous operation at a maximum burn can, how- ever, shorten the life of the electrical components (blowers, motors, and electronic controls), and is not recommended. Typical approved operation would include running at the low to mid range set- ting with occasional running on the maximum set- ting during the coldest periods of the winter. The room air blower speed control should be turned to high when operating the stove on the high heat setting.
11.CAUTION: NEVER PUT FINGERS NEAR AUGER. Pellet fuel is fed to the UltraGrateTM by a screw au- ger. This auger is driven by a high torque motor.
The auger is capable of doing serious harm to fin- gers. Keep pellets in the hopper at all times and keep fingers away from auger. The auger can start and stop automatically at any time while the stove is running.
12.CAUTION: HOT WHILE IN OPERATION. An appli- ance hot enough to warm your home can severely burn anyone touching it. Keep children, clothing and furniture away. Contact may cause skin burns. Do not let children touch the appliance. Train them to stay a safe distance from the unit.
13.APPROVED FUEL: This appliance is designed spe- cifically for use only with pelletized wood fuels only. With its advanced UltraGrateTM technology, this appliance is designed and approved for the burning of wood residue pellets with up to 3% ash content. This appliance is NOT approved to burn cardboard, nut hulls, cherry pits, corn, etc. regard- less if it is in pellet form. Failure to comply with this restriction will void all warranties and the safety listing of the stove. Consult with your authorized Lennox Hearth Products dealer for approved pellet fuels.
14.FLY ASH
15.SOOT FORMATION: Incomplete combustion can occur during startup, shutdown, or incorrect op- eration of the room heater. This can lead to some soot collecting in the exhaust venting system. A precautionary inspection on a regular basis is ad- visable to determine the necessity of cleaning. The exhaust venting system should be inspected regu- larly and cleaned as necessary.
16.DISPOSING OF ASHES: Any ashes removed from the pellet stove must be deposited in a metal con- tainer with a
17.SAVE THESE INSTRUCTIONS.
18.See the listing label located in the hopper (or see Safety / Listing Labels on page 43).
PAGE 2
www.PelletKing.com