Lennox Hearth II-T C FS Installation, Removing Appliance From Pallet, Underside of Pallet

INSTALLATION

REMOVING APPLIANCE FROM PALLET

1.After removing the packaging from the stove, lift the hopper lid, and remove all pre-packaged items that were shipped in the hopper. Next, open the stove door and remove all pre-packaged items.

2.Using a 9/16” socket or open end wrench, remove the bolts which secure stove to pallet. The bolts are located on the underside of the wooden pallet.

Underside of Pallet

Remove the two bolts from underneath the pallet.

NOTE: Bolts may be used in manufactured (mobile) home installation to permanently secure stove to floor (see previous page).

ASH PAN COVER ASSEMBLY

Remove the ash pan cover trim from hopper. Remove polyfoam wrapping and press into place as shown in il- lustration below. The ash pan cover trim has two mag- nets attached which will secure it in place.

Ash Pan Cover

INSTALLING PEDESTAL TO BODY

If your stove is a freestanding model, secure the pedes- tal to the stove body as follows:

1.Remove the pedestal from the box and place it be- side the stove body.

2.Lift the stove onto the pedestal base.

3.Install the three bolts and washers provided through the holes in the mounting flange of the pedestal and into the threaded pressed nuts in the stove bottom.

4.Tighten the fasteners using a socket or wrench.

Pedestal – Top View

Install three bolts

Attach stove to pedestal by inserting three bolts (provided with pedestal kit)

PAGE 9

www.PelletKing.com