5.Install the rear I/O shielding. See “Installing the rear I/O shielding” on page 78.
6.Go to “Completing the FRU installation” on page 109.
Replacing the rear I/O shielding
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important Safety Information” on page 1.
This section provides instructions on how to replace the rear I/O shielding.
Removing the rear I/O shielding
To remove the rear I/O shielding, do the following:
1.Turn off the computer.
2.Disconnect all cables, power cords, and external options from your computer. See “Locating connectors on the rear of your computer” on page 68.
3.Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay it down so that the screen is against the surface and the cover is facing up.
4.Remove the computer cover. See “Removing the computer cover” on page 74.
5.Locate the rear I/O assembly on the system board. See “Locating parts on the system board” on page 71.
6.Remove the two screws that secure the rear I/O shielding to the rear I/O assembly. Carefully remove the rear I/O shielding from the rear I/O assembly.
Installing the rear I/O shielding
To install the rear I/O shielding, do the following:
1.Replace the rear I/O shielding over the rear I/O assembly and make sure the connectors on the rear I/O assembly are aligned with the holes in the rear I/O shielding.
2.Install the two screws that attach the rear I/O shielding to the rear I/O assembly.
