Note: When the power cord is first plugged in, the computer might appear to turn on for a few seconds and then turn off. This is a normal sequence for the computer to initialize.
Installing a computer cover
To install a computer cover, do the following:
1.Replace the two rubber tabs you had previously removed.
2.Replace the cover so that the slots on the top edge of the computer cover align with the tabs on the computer.
3.Lower and press one end of the computer cover into place first and then close the other end until the computer cover fits snugly on the computer.
4.Use the screwdriver to tighten the two screws computer.
1
until the computer cover is fully installed on the
Installing a computer stand
To install a computer stand, do the following:
1.Turn off the computer.
2.Disconnect all cables, power cords, and external options from your computer. See “Locating connectors on the rear of your computer” on page 68.
3.Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay it down so that the screen is against the surface and the bottom is facing you.
4.Position the computer stand over the back of the computer and insert the two tabs at the front of the computer stand into the two holes in the cover at an angle.
