Replacing the power supply
Attention
Never remove the cover on a power supply or any part that has the
following label attached.
Hazardous voltage, current, and energy levels are presentinside any
component that has this label attached. There are no serviceable parts inside
these components.
This procedure describes how to remove and replace the power supply.
1. Remove the cover. See “Removing the cover” on page 89.
2. Remove the drive bay assembly.See “Accessing system board components
and drives” on page 90.
3. Disconnect all power supply cables from the system board. See the system
board diagram for your machine type at “System board connectors” on page
88.
4. Remove the hard disk drive. See “Replacing the hard disk drive” on page 103.
Note: Observe the power supply cable routing underneath the hard disk
drive.
5. The system board must be moved out of the way to remove the power supply.
Remove the screws that secure the system board to the chassis and slide the
system board away from the power supply.
Note: Youdo not have to remove the system board from the chassis to
remove the power supply.
6. At the rear of the chassis, remove the three screws that securethe power
supply.Also remove the screw that secures the power supply at the front.
94 HardwareMaintenance Manual