Replacing the power switch/LED assembly
This procedure describes how to remove and replace the power switch/LED
assembly.
1. Remove the computer cover. See “Removing the cover” on page 117.
2. Remove the front bezel. See “Removing and replacing the front bezel” on
page 118
3. Disconnect the power switch/LED assembly cable from the system board. See
the system board illustration for your machine type at “System board
connectors” on page 116.
4. Note the power switch/LED assembly cable routing and the position of the
two LEDs.
5. Remove the switch/LED from the bezel.
6. Route the cable for the new power switch/LED assembly through the hole in
the chassis and to the system board.
7. Install the new power switch/LED assembly into the bezel. Make sure that the
LEDs are in the correct position.
8. Connect the power switch/LED cable to the system board.
9. Reinstall the front bezel.
10. Go to “Completing the FRU replacement” on page 147.
Chapter9. Replacing FRUs - Tower Computers 145