Replacing the system fan assembly
This procedure describes how to remove and replace the system fan assembly.
1. Remove cover. See “Removing the cover” on page 89.
2. Toaccess system board components. See “Accessing system board components
and drives” on page 90.
3. Remove the hard disk drive. See “Replacing the hard disk drive” on page 103.
4. Disconnect the system fan cable from the system board. See “System board
connectors” on page 88.
5. Remove the two screws securing the system fan assembly.
6. Remove the system fan assembly by pulling the bracket outward and lifting it
up from the system board to remove completely.
7. Install the new system fan assembly and install the two screws that secure the
fan assembly.
8. Connect the system fan cable to the system fan connector on the system
board.
9. Reinstall the hard disk drive. See “Replacing the hard disk drive” on page
103.
10. Align the drive bay assembly with the two slots and rails on the sides of the
chassis and slide the drive bay assembly towards the rear of the chassis until
it snaps into position.
11. Reinstall the front bezel.
12. Go to “Completing the FRU replacement” on page 111.
Chapter8. Replacing FRUs- Rocky computers 109