Replacing the primary hard disk drive
Important
When a new hard disk drive is installed, a set of Product Recovery discs might
be required. The set of Product Recovery discs enable the contents of the hard
disk to be restored to the same state as when the computer was originally
shipped from the factory.For more information on recovering
factory-installed software, refer to Recovering Softwarein the User Guide.
This procedure describes how to remove and replace the primary harddisk drive.
1. Remove the computer cover. See “Removing the cover” on page 117.
Note: For this procedure, it helps to lay the computer on its side.
2. Disconnect the signal and power cables from the hard disk drive.
3. Press the release tab 1 down, slide the hard drive cage 2 back, and pivot
the hard disk drive outward as shown.
4. Remove the hard disk drive cage from the chassis by simply sliding it
outward.
5. Pull on the blue handle 3 to remove hard disk drive from the drive cage.
6. Remove the failing hard disk drive from the blue plastic bracket from by
flexing the sides of the bracket enough to free it from the hard disk drive.
Chapter9. Replacing FRUs - Tower Computers 131