| • | N/A No disk is available. |
| • | No Scan performed No Scandisk has been performed recently |
|
| on this drive. |
| • | Scandisk in progress Scandisk operation is in progress. The |
|
| disk cannot be used while a Scandisk is in progress. If required, |
|
| use the "Start/Stop" button to terminate the Scandisk operation |
|
| and gain access to data on the disks. (To see the results of the |
|
| Scandisk operation, use the "View Disk Log" button.) |
| • | Scandisk completed The last Scandisk operation has been |
|
| completed. You can use the "View Disk Log" button to view the |
|
| results. |
| • | Scandisk terminated The last Scandisk operation was can- |
|
| celled by the Administrator before it was completed. |
| Run Scandisk - Select the day and time you wish the Scandisk to be | |
| done. (Select "Never" if you don't wish the scandisk to run automati- | |
| cally.) | |
|
|
|
Buttons |
|
|
Prepare Disk | Use this button to start preparing the disk. This will partition and | |
| ||
| WARNING! This will destroy any data on the disk. Once started, this | |
| process can NOT be halted or reversed. | |
|
| |
Run Check - Select the day and time you wish the S.M.A.R.T. check | ||
(S.M.A.R.T.) | to be done. (Select "Never" if you don't wish the S.M.A.R.T. check to | |
| be performed automatically.) | |
| Test now - Click this button to run the S.M.A.R.T. check immediately. | |
| The check will take no more than a few minutes. | |
|
| |
Scandisk | Start/Stop - If a Scandisk is in progress, click this button to terminate | |
| the Scandisk immediately. Otherwise, clicking the button will start the | |
| Scandisk. The Scandisk could take a few hours, and the disk is un- | |
| available to users while the Scandisk is in progress. | |
|
| |
Standby | Use the "Set Hard Disk to standby mode.. " setting to determine if and | |
| when the hard disk drives should be switched to "Standby" mode. | |
|
| |
Save | Save the settings on this screen. This has no effect on any operations in | |
| progress. | |
|
| |
Cancel | Restore the settings on the screen to their values after the last "Save" | |
| operation. Clicking "Cancel" has NO EFFECT on any operations in | |
| progress. | |
|
| |
Disk Log | Use this to view the results of the last Scandisk operation. | |
|
|
|
Page 38
