Getting Familiar with your NAS

LEDs

LED

Function

Ready

ON – Normal operation.

 

OFF – No power.

 

Blinking – This LED blinking during startup and shutdown.

 

 

Status

ON – This LED will be On during the Startup self-test; it will turn Off once

 

 

the self-test is completed. If it stays ON, there is a hardware error.

 

OFF – Normal operation.

 

Blinking – During a software upgrade, both the Status and Ready LEDs will

 

 

blink.

Disk

OFF - Idle.

 

Blinking – Hard disk is being accessed.

 

 

Disk Full

ON - Disk is completely full. No more data can be stored on this disk

 

OFF -Normal operation, disk is not full.

 

Blinking - Disk is 98% full (The Buzzer will also beep 3 times.)

 

 

USB

ON - USB device connected to the USB port

 

OFF - No USB device installed

 

Fast Blinking - Data being transferred to or from the USB device

 

Slow Blinking – USB device can be removed safely

 

 

Ethernet

ON – Link established.

 

OFF – No LAN connection.

 

Blinking – Data is transmitted or received via the LAN.

Rear Panel

 

Read Panel

 

 

Power Input

Connect the supplied power adapter here.

 

 

Reset Button

This button has 2 functions:

(IP/Password)

If the NAS's IP Address is lost, press and hold this button for 2 seconds. The

 

 

IP Address will be set to the default value of 192.168.0.100 (Network Mask

 

of 255.255.255.0) and it will beep once to indicate the reset has occurred

 

If the NAS administrator’s password is lost, press and hold this button for 10

 

seconds. The password will then be cleared (no password), and the NAS will

 

beep again.

USB Port

Connect your USB Hard Disk Drive or USB Flash Drive here. The USB HDD

Page 3

Page 5
Image 5
LevelOne FNS-1000 user manual Getting Familiar with your NAS, LEDs, Rear Panel, Function