Lexmark 249X Set Horizontal Tabs by Dot Columns, Pitch Shift Increment, Indent from Left Margin

Name	Dec	Hex	Description
ESC ETX ...	27 3 x1 y1	1B 03 x1 y1	Set Horizontal Tabs by Dot Columns
CR	z1 w1...x16	z1 w1...x16	Sets tab stops for up to 16 positions. The character
	y16 z16	y16 z16 w16	pitch determines the distance represented by the
	w16 13	0D	tab (distance from the center of one dot to the
			center of the next dot).
			Pitch	Shift Increment
			10 cpi		1/120
			12 cpi		1/144
			15 cpi		1/180
			17.1 cpi		1/206
			20 cpi		1/240
			The values for x, y, z and w must be entered as
			four-digit ASCII numbers (use leading zeros if
			necessary), separated by commas, and in
			ascending order.
			To calculate the value, multiply the position for
			which you want to set a tab by the pitch increment
			of shift, and then subtract one from the product.
			For example, to set a tab for 2" from the left margin
			using 12 cpi pitch, multiply 2 by 144, and then
			subtract 1. The value would be 0287.
			Maximum values are as follows:
			Pitch	2480	2481
			10 cpi	959	1631
			12 cpi	1151	1956
			15 cpi	1339	2447
			17.1 cpi	1643	2795
			20 cpi	1917	3261
ESC HT	27 9 13	1B 09 0D	ESC HT CR
CR			Clears horizontal tabs set by character spacing.
ESC % B	27 37 66 n1	1B 25 42 n1	Indent from Left Margin
	n2 n3 n4	n2 n3 n4	See the command ESC ETX ... CR on page 86 for
			instructions on calculating the value for n1...n4.
			(Use the same pitch increment of shift values as the
			ESC ETX ... CR command.)

86 Section 5: OKI Microline Emulation Mode Printer Commands