Learning about the printer | 12 |
3Open the manual feeder, and then move the paper select lever to the 
position.
4Move the left paper guide to the right until it stops.
5Insert a single sheet of paper into the front of the printer.
6Adjust the right paper guide to fit the paper width.
7Continue to push the paper into the printer until the Paper Out light stops blinking.
•If Auto Cut Sheet Load is set to On, the paper feeds automatically to the Top‑Of‑Form.
•If Auto Cut Sheet Load is set to Off, press FormFeed.
8Turn the printer off.
9While pressing Font on the control panel, turn the printer on. Hold down the Font button until all the control panel lights blink.
10Release the Font button.
The Power and Ready lights stay on, and the demonstration page prints.
Printing a network setup page
If the printer is attached to a network, print a network setup page to verify the network connection and find the printer address.
