Troubleshooting | 67 |
Buttons do not work, except for Start/Stop, FormFeed, Tear Off and Load/Unload
1Turn the printer off.
2Press and hold Load/Unload and Tractor while turning the printer on.
When the 
light goes off, the control panel is unlocked, and all buttons are active.
Printer power switch is on, but the power light is off
These are possible solutions. Try one of more of the following:
•Make sure the power cord is correctly connected at both ends.
•Verify that the power source works.
•Turn the printer off and then back on.
Left margin moves to the right during printing
These are possible solutions. Try one or more of the following:
•Make sure the ribbon cartridge is properly installed, and the paper is correctly loaded.
•Make sure the carrier packing tape has been removed.
•Check to see if anything is blocking the carrier movement.
•If a paper jam has recently occurred, turn the printer off and then back on.
•Contact Customer Support.
Incorrect line length; lines do not start at the left margin
These are possible solutions. Try one or more of the following:
•See the documentation that came with the program.
•Make sure the correct printer driver is selected.
•Adjust the left margin by adjusting the tractor or paper guide.
Printer speed slows
These are possible solutions. Try one of more of the following:
•Make sure the forms thickness lever setting is appropriate for the thickness of the forms being used. Printing speed is slower when the forms thickness lever is set at 4 or higher. This is normal.
•Select resident fonts.
Note: Automatic thermal slowdown protects the printhead from overheating. This operation is normal and is affected by the print type being used (letter quality, etc.) and the amount and density of graphics being printed.
