Lexmark 4600 Series manual Press to print the photos

Notes:

•If you insert the camera while the printer is performing another job, wait for the job to finish before printing from the camera.

•To use the camera to control printing photos, see the instructions in the camera documentation.

Printing photos stored on a memory device using the proof sheet

1Load letter- or A4-size plain paper.

2From the printer control panel, press .

3Insert a memory card or flash drive.

4Press the arrow buttons until Proof Sheet appears, and then press .

5Press the arrow buttons to select an option to print a proof sheet. You can print a proof sheet:

•For all photos on the memory device.

•For the 20 most recent photos, if there are 20 or more photos on the memory device.

•By date, if the photos on the card were taken on different dates. If you choose this option, use the arrow buttons on the printer control panel to choose the date range, and then press to save your selections.

6Press .

The proof sheets prints.

7Follow the instructions on the proof sheet to select which photos to print, the number of copies per photo, red-eye reduction, page layout, print options, and paper size.

Note: When making selections, make sure to fill in the circles completely.

8Load the proof sheet facedown on the scanner glass.

Scan Proof Sheet appears on the display.

Note: If this option does not appear on the display, then press the arrow buttons until it appears on the display.

9Press .

The printer scans the proof sheet.

10Load photo paper vertically in the center of the paper support, with the glossy or printable side facing you. (If you are not sure which side is the printable side, then see the instructions that came with the paper.)

Note: Make sure that the paper matches the size that you selected on the proof sheet.

11Press to print the photos.

Note: To prevent smudging or scratching, avoid touching the printed surface with your fingers or sharp objects. For best results, remove each printed sheet individually from the paper exit tray, and then allow the prints to dry at least 24 hours before stacking, displaying, or storing.

82