Lexmark 90T7005, Pro700 Series Faxing FAQ, Receiving a fax manually, Tips

2Set the number of rings before the printer picks up incoming faxes:

aPress the arrow buttons to scroll to Pick Up On, and then press .

bPress the arrow buttons to scroll to the number of rings that you want, and then press to save the setting. When the number of rings you set is detected, the printer automatically receives the incoming fax.

Warning—Potential Damage: Do not touch the cables or the and ports while actively receiving a fax.

Tips:

•If the printer is sharing the line with other analog devices (telephone, answering machine), then set the printer to pick up calls two rings after the answering machine. For example, if the answering machine picks up calls after four rings, then set the printer to pick up after six rings. This way, the answering machine picks up calls first and your voice calls are received. If the call is a fax, then the printer detects the fax signal on the line and takes over the call. If the printer is on a dedicated fax line, then you may set the printer to pick up on any number of rings.

•If you have multiple numbers on a single line, or if you subscribe to a distinctive ring service provided by your telephone company, then make sure that you set the correct ring pattern for the printer. Otherwise, the printer will not receive faxes even if you have set it to receive faxes automatically.

Receiving a fax manually

1Turn off Auto Answer:

aFrom the printer control panel, press .

bPress the arrow buttons to scroll to Fax Setup, and then press .

cPress the arrow buttons to scroll to Ringing and Answering, and then press .

dPress again to select Auto Answer.

ePress the arrow buttons to scroll to Off, and then press .

2When the telephone rings and you hear fax tones when you pick up the handset, press on the printer or *9* on the telephone attached to the printer.

Warning—Potential Damage: Do not touch the cables or the and ports while actively receiving a fax.

Tips:

•The default code for answering faxes manually is *9*, but for increased security, you can change it to a number that only you know. You can enter up to 7 characters for your code. The valid characters are the digits 0-9 and the characters # and *.

•Make sure that the telephone is plugged into the port on the back of the printer and that the printer is connected to the wall jack through the port.

Faxing FAQ

If I skipped the fax setup initially, do I need to run the installer again to set up the fax?

You do not need to run the installer again. You can set up and configure the fax through the fax software that was installed with the printer software.

Faxing

86