LG Electronics LRG30855ST After a clean cycle, Clean cycle, Display, Locked Door light, To cook

T RO U B L E S H O OT I N G

BEFORE CALLING FOR SERVICE

Problem	Possible Causes	Solutions
Oven door will not open	• Oven too hot.	•	Allow the oven to cool below locking temperature.
after a clean cycle
Oven not clean after a	• Oven controls not properly set.	•	See the Using the Self-Cleaning Oven section.
clean cycle	• Oven was heavily soiled.	•	Clean up heavy spillovers before starting the clean
			cycle. Heavily soiled ovens may need to self-clean
			again or for a longer period of time.
“LOCK DOOR” flashes	• The self-clean cycle has been	•	Close the oven door.
in the display	selected but the door is not
	closed.
LOCKED DOOR light	• The oven door is locked	•	Touch the CLEAR/OFF pad. Allow the oven to cool.
is on when you want	because the temperature
to cook	inside the oven has not
	dropped below the
	locking temperature.
“F—and a number or	• You have a function error code.	•	Touch the CLEAR/OFF pad. Allow the oven to cool for
letter” flash in the display			one hour. Put the oven back into operation.
	• If the function code repeats.	•	Disconnect all power to the range for 5 minutes
			and then reconnect power. If the function error
			code repeats, call for service.
Oven shelves are	• The nickel shelves (if so equipped)	•	Apply a small amount of vegetable oil to a paper
difficult to slide	were cleaned in a self-clean cycle.		towel and wipe the edges of the oven shelves with
			the paper towel. Do not spray with Pam® or other
			lubricant sprays.
“Probe” appears	• This is reminding you to enter a	•	Enter a probe temperature.
in the display	probe temperature after plugging
(convection models)	in the probe.
Display goes blank	• A fuse in your home may be blown	•	Replace the fuse or reset the circuit breaker.
	or the circuit breaker tripped.
	• The clock is in the	•	See the Special Features of Your Oven Control
	black-out mode.		section.
Display flashes	• Power failure.	•	Reset the clock.
Unable to get the	• Oven control pads were	• The BAKE and BROIL HI/LO pads must be touched
display to show “SF”	not pressed properly.		at the same time and held for 3 seconds.
Power outage,	• Power outage or surge.	• Reset the clock. If the oven was in use, you must
clock flashes			reset it by touching the CLEAR/OFF pad, setting the
			clock and resetting any cooking function.

44