16Installation
2. Detach the top case by sliding it after removing the screws. You | Replacing the Hard Disk Drive | |
must lift up the top case verticality. | Turn the power of the unit off and detach the power plug from the | |
| ||
| outlet. | |
| 1. | Follow steps 1 to 3 described in “Installing the Hard Disk Drive”. |
| 2. | Remove the connector from the HDD. |
| 3. | Remove the screws from the hard disk drive on the bottom of |
|
| the hard disk mounting bracket. |
| 4. | Replace the new HDD. |
3. Remove the screws and detach the hard disk mounting brackets | 5. | Follow steps 4 to 10 described in “Installing the Hard Disk Drive”. |
from the unit. | 6. | After replacing the hard disk drive, insert the power plug into |
| ||
|
| the outlet and turn the power of the unit on. The new HDD is |
3 |
| detected and formatted. |
Installation |
| NOTE |
|
| |
| • Do not use an electric screwdriver to fix them. | |
| automatically. |
|
| • Make sure that each of the SATA cables is connected to the | |
|
| connector housing through its holes. |
| • Do not stack them nor keep them upright. | |
4. Attach the HDD onto the hard disk mounting brackets with four | Recommended HDD | |
For the latest recommended HDD list, please visit | ||
screws. | ||
http://www.lgecommercial.com | ||
| ||
| NOTE | |
| If you do not use the recommended HDD, the system may not be | |
| operated normally. |
5.Attach the hard disk mounting brackets with the screws.
6.Connect the HDD power cable. You must use the supplied SATA power cable. The SATA power cable that used for normal PC is not compatible with this unit.
7.Connect the Serial SATA cable.
8.Connect the SATA cable of the HDD to the SATA connector of the main board.
9.Assemble the top case.
10.Fix the screws.
11.When you turn the power of the unit on, the new HDD is detected and formatted automatically.
