Section 2: Start Up

To start up the RAC2-8:

1.Mount unit to wall.

2.Connect cables.

3.Set switches and jumpers on circuit boards as required for your application. Refer to instructions and illustrations in SECTION 5

— INSTALLATION.

4.Make user programmable selections from the local control panel or from an optional remote terminal. Refer to SECTION 4 — GLOSSARY OF CONTROL FUNCTIONS and SECTION 3 —

OPERATION.

5.Apply power to the unit. Note that the ON/OFF switch is inside the enclosure.

Figure 2–1. Local Control Panel

Liebert RAC2-8 3

Page 8
Image 8
Liebert manual To start up the RAC2-8, Installation, Operation