CoolTherm
Manual / Bedienungsanleitung
Remove both screws
5.3Chilled water connection
The heat exchanger can be pulled out for servicing
Chilled water pipes should be connected so that the heat exchanger can be pulled out when the connection is undone.
If the heat exchanger is connected to the chilled water network using threaded fittings, the pipe fitting must be supported on tightening.
Prior to commissioning the server cabinet, the pipe connections should be checked for leaks.
Preparing heat exchanger for initial commissioning:
-Check the mechanical installation and the supply pipe connection.
Remove this air duct for bleeding, draining the heat exchanger and checking the valve
CoolTherm | 01_998_330_0_k | page / Seite 21/83 |
