OPERATION |
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
TO START THE WELDER
Turn the Power Switch switch to ON. This lights the red LED display lights. With the desired voltage and wire speed selected, operate the gun trigger for welder out- put and to energize the wire feed motor.
FEEDING WIRE ELECTRODE
WARNING
When triggering, the electrode and drive mecha- nism are electrically “hot” relative to work and ground and remain “hot” several seconds after the gun trigger is released.
NOTE: Check that drive rolls, guide plates, and gun parts are proper for the wire size and type being used. Refer to Table C.1 in Accessories section.
1.Turn the
2.While securely holding the electrode, cut off the bent end and straighten the first six inches. (If the electrode is not properly straightened, it may not feed properly through the wire drive system.)
3.Release the pressure on the idle roll by swinging the adjustable pressure arm down toward the back of the machine. Lift the cast idle roll assem- bly and allow it to sit in an upright position. Leave the outer wire guide plate installed. Manually feed the wire through the incoming guide bushing and through the guide plates (over the drive roll groove). Push a sufficient wire length to assure that the wire has fed into the gun and cable assembly without restriction. Reposition the adjustable pressure arm to its original position to apply pressure to the wire.
4.Press gun trigger to feed the electrode wire through the gun.
2.If the wire “birdnests”, jams, or breaks at the drive roll, the idle roll pressure is too great. Back the adjustment knob out 1/2 turn, run new wire through gun, and repeat above steps.
3.If the only result was drive roll slippage, loosen the adjustment knob on the conductor plate and pull the gun cable forward about 6 in. (15 cm). There should be a slight waviness in the exposed wire. If there is not waviness, the pressure is too low. Tighten the adjustment knob 1/4 turn, reinstall the gun cable and repeat the above steps.
SETTING RUN-IN SPEED ON STAN- DARD POWER MIG FEEDER
FAST OR SLOW
The POWER MIG 255 is factory set for fast
Slow
NOTE: See operating instructions for Timer Option Kit if it is installed, as it provides its own
INSTRUCTIONS TO ENTER SLOW RUN-IN
1.Turn power OFF on front panel of POWER MIG 255.
2.Turn the wire feed speed dial fully counterclock- wise to minimum.
3.With the gun trigger closed, turn the power ON at the front panel of the POWER MIG 255.
4.The display will read “SLO run”.
Return to Section TOC
Return to Master TOC
IDLE ROLL PRESSURE SETTING
The idle roll pressure adjustment knob is set at the fac- tory at the #2 hash mark. This is an approximate set- ting. The optimum idle roll pressure varies with type of wire, wire diameter, surface conditions, lubrication, and hardness. As a general rule, hard wires may require greater pressure, and soft, or aluminum wire, may require less pressure than the factory setting. The opti- mum idle roll setting can be determined as follows:
1.Press end of gun against a solid object that is electrically isolated from the welder output and press the gun trigger for several seconds.
INSTRUCTIONS TO ENTER FAST RUN-IN
1.Turn power OFF on front panel of POWER MIG 255.
2.Turn the wire feed speed dial fully clockwise to maximum.
3.With the gun trigger closed, turn the power ON at the front panel of the POWER MIG 255.
4.The display will read “FAS run”.
POWER MIG 255
