Linksys SRW208 manual 1000Mbps, and adjust its speed and duplex accordingly

WebView Switches

Ports

1-8	The Switch is equipped with 8 auto-sensing, Ethernet network ports, which use RJ-45
	connectors. The Fast Ethernet ports support network speeds of 10Mbps or 100Mbps.
	They can operate in half and full-duplex modes. Auto-sensing technology enables each
	port to automatically detect the speed of the device connected to it (10Mbps or 100Mbps),
	and adjust its speed and duplex accordingly.
G1	The Gigabit Ethernet port supports network speeds of 10Mbps, 100Mbps, and 1000Mbps.
	It can operate in half and full-duplex modes. Auto-sensing technology enables the port to
	automatically detect the speed of the device connected to it (10Mbps, 100Mbps, or
	1000Mbps), and adjust its speed and duplex accordingly.
G2	The mini-GBIC (gigabit interface converter) port is a connection point for a mini-GBIC
	expansion module, so the Switch can be uplinked via fiber to another switch. The MiniGBIC
	port provides a link to a high-speed network segment or individual workstation at speeds
	of up to 1000Mbps.
	Use the Linksys MGBT1, MGBSX1, or MGBLH1 mini-GBIC modules with the Switch. The
	MGBSX1 and the MGBLH1 require fiber cabling with LC connectors, while the MGBT1
	requires a Category 5e Ethernet cable with an RJ-45 connector.
Console	The Console port is where you can connect a serial cable to a PC’s serial port for
	configuration using your PC’s HyperTerminal program. Refer to Chapter 4: Using the
	Console Interface for Configuration for more information.

Chapter 2: Getting to Know the Switch 6

SRW208G - Front Panel