Linksys SRW208 manual QoS Tab - DSCP Settings, QoS Tab - Bandwidth

WebView Switches

QoS Tab - DSCP Settings

The DSCP Settings screen enables mapping DSCP values to specific queues.

The DSCP Settings screen contains the following fields:

DSCP. Indicates the Differentiated Services Code Point value in the incoming packet.

Queue. Maps the DSCP value to the selected queue.

QoS Tab - Bandwidth

The Bandwidth screen allows network managers to define the bandwidth settings for a specified egress interface. Modifying queue scheduling affects the queue settings globally. The Bandwidth screen is not used with the Service mode, as bandwidth settings are based on services.

Queue shaping can be based per queue and/or per interface. Shaping is determined by the lower specified value. The queue shaping type is selected in the Bandwidth screen.

Interface. Indicates the interface for which the queue shaping information is displayed. The possible field values are:

•Port. Indicates the port for which the bandwidth settings are displayed.

•LAG. Indicates the LAG for which the bandwidth settings are displayed.

Ingress Rate Limit Status. Indicates if rate limiting is defined on the interface.

Rate Limit (62-1000000 Kbps). Defines the amount of bandwidth assigned to the interface. The possible field values are 62-1000000 Kbps.

Egress Shaping Rate on Selected Port. Indicates if rate limiting is enabled on the interface.

Committed Information Rate (CIR). Defines CIR as the queue shaping type. The possible field value is 64 - 1,000,000 Kbps.

Committed Burst Size (CBS). Defines CBS as the queue shaping type. The possible field value is 4096- 16,769,020 bits. Committed Burst Size cannot be configured on FE ports.

The Add to List button adds the Bandwidth configuration to the Bandwidth Table at the bottom of the screen.

Chapter 5: Using the Web-based Utility for Configuration

Figure 5-38: QoS - DSCP Settings

Figure 5-39: QoS - Bandwidth

63

QoS Tab - DSCP Settings