Wireless-G Internet Video Camera
Chapter 4: Connecting the Wireless-G Internet Video Camera for Setup
Overview
Before you set up the Camera, connect it to a wired or wireless network. Proceed to the appropriate section for your setup.
If you need to move the Camera from a wired network to a wireless network, or vice versa, go to this section, “Moving the Camera to a Different Network.”
Connection to a Wired Network for Setup
1.Attach the antenna.
2.Connect the Ethernet network cable to your router, switch, or computer.
3.Connect the other end of the cable to the Ethernet port on the Camera. See Figure
4.Connect the power adapter to the Power port on the Camera.
5.Plug the power adapter into an electrical outlet.
The Camera’s Ready LED flashes while the Camera is initializing. The Camera is ready for use when the Ready and Ethernet LEDs are solidly lit.
Proceed to “Chapter 5: Setting up and Mounting the
Connection to a Wireless Ad-Hoc Network for Setup
1.Make sure your computer has the following wireless settings:
•SSID - linksys
•Network Mode -
•Channel - 6
•WEP - Disabled
2.Attach the antenna.
Chapter 4: Connecting the
Figure 4-1: Connect the Ethernet Network Cable
NOTE: You MUST connect the Camera to a PC, router, or switch using the Ethernet network cable BEFORE powering on the Camera. Otherwise, the Camera will not function.
Figure 4-2: Connect the Power Adapter
8
Overview
