3.4HARDWARE OPTIONS

3.4.1Configuration Jumpers and Connections

This section includes setup and configuration information for Maxtor Atlas 10K V drives. These disk drives include

•The 16-bit multimode Ultra320 SCSI, wide version with 68-pin SCSI connector,

•The 16-bit multimode Ultra320 SCSI, version with SCA-2 80-pin connector.

Specific individual settings for each drive type are described in Sections 3.5.1 through 3.5.4.

CAUTION: Before you begin, review the Safety, ESD, and Handling precautions described at the beginning of this manual to avoid personal injury or damage to equipment.

3.4.2Jumper Options on the 68-Pin Wide PCB

This section describes how to configure the jumpers on Maxtor Atlas 10K V disks with 68-pin SCSI interface connectors. The following features are jumper- selectable:

•SCSI ID (0), (1), (2), (3) – SCSI Bus Device Identification

•Delay Spin

•Single-Ended, Disable LVD

•Busy Out (Remote LED)

•Write Protect

•Stagger Spin

Note: The disk drive does not support on-board SCSI termina- tion.

Note: The configuration of a Maxtor Atlas 10K V hard disk drive depends on the host system in which it is to be in- stalled. Figure 3-3shows the printed circuit board (PCB) assemblies for 68-pin SCSI configurations, indicating the jumpers that control some of these options.

3-6 Maxtor Atlas 10K V