3.4.3.2SCSI ID for SCA-2 Versions

Each SCSI device on the bus must have a unique SCSI ID number assigned to it. The drive can be configured for SCSI ID numbers that range from 0 through 15.

Configure the SCSI ID by providing the proper open or ground signal inputs to the referenced pins of the drive’s 80-pin new version SCA-2 connector (Figure 3-4). Refer to Table 3-2for SCSI ID pin assignments.

Note: Refer to your system or SCSI controller documentation for specific recommendations about assigning SCSI ID numbers for your specific system.

Figure 3-4Pin Locations on SCA-2 Connector

Maxtor Atlas 10K V 3-11