3.4.3SCA-2 80-Pin Connector Versions

This section describes the SCA-2 (Single Connector Attachment) 80-pin connector for Maxtor Atlas 10K V drives with the following features:

•SCSI ID

•Spin Up

•Activity LED displays

Use Figure 3-4to locate the appropriate pins for configuring the drive. Note that Figure 3-4does not call out each of the 80 pins on the connector, but rather illustrates the layout of the pins.

Note: The SCA-2 Connector version of the disk drives does not provide the following jumper configuration: TERMPWR, Active Termina- tion, or Write Protection.

3.4.3.1Termination for the 80-Pin SCA-2 Connector Versions

CAUTION: These versions of Maxtor Atlas 10K V disk drives cannot be configured to provide bus termination. Therefore, be sure to properly terminate the SCSI bus on which this drive is in- stalled.

Note: Refer to your system or SCSI controller documentation regarding any additional recommendations regarding drive placement on the SCSI bus and SCSI bus termination.

3-10 Maxtor Atlas 10K V