3.6.2Mounting Screw Clearance

The printed-circuit board assembly (PCBA) is very close to the mounting holes. Figure 3-7 specifies the clearance between the screws in the mounting holes and the PCBA. Do not use mounting screws longer than the maximum lengths specified in Figure 3-7. The specified screw length allows full use of the mounting-hole threads, while avoiding damaging or placing unwanted stress on the PCBA. Clearance from the drive to any other surface (except mounting surfaces) must be a minimum of 1.25 mm (0.05 inches).

Figure 3-7Mounting Screw Clearance for Maxtor Atlas 10K V Drive

CAUTION: The PCB is very close to the mounting holes. Do not exceed the speci- fied length for the mounting screws. The specified screw length allows full use of the mounting-hole threads, while avoiding damaging or placing unwanted stress on the PCB.

Figure 3-7 specifies the minimum clearance between the PCB and the screws in the mounting holes. The maximum torque applied to the screws must not exceed 8.6 inch-pounds.

3-22 Maxtor Atlas 10K V

Page 46
Image 46
Maxtor manual 7Mounting Screw Clearance for Maxtor Atlas 10K V Drive