Disassembly Procedures
!WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect power to unit before servicing.
Oven Door Hinge
1.Turn off power to unit.
2.Remove oven door, see “Door Removal”.
3.Carefully open the hinge fully, and insert a wooden dowel or screwdriver bit into opening marked A on the following diagram.
4.Remove the top and bottom screws securing hinge assembly to the front frame.
5.Slide the hinge assembly up and move top of hinge towards rear of the range. Withdraw hinge assembly through the frame opening.
6.Reverse procedure to reinstall oven door hinge assembly.
Blower Motor
1.Turn power off to unit.
2.Open oven door and remove screws securing unit to the wall.
3.Remove oven from cutout opening.
4.Disconnect or unplug the power cord leading from unit to fuse box or junction box depending on unit.
5.Remove screws securing outer wrapper top cover to outer wrapper cover.
6.Remove screws securing blower vent bracket to outer wrapper cover and blower motor assembly.
7.Disconnect and label wire terminals connected to blower motor.
8.Remove screws securing blower motor assembly to vent assembly.
9.Reverse procedure to reinstall.
Vent Assembly/Smoke Eliminator
1.Perform steps 1 through 8 of “Blower Motor”.
2.Remove screws securing vent assembly to outer cabinet top wrapper.
3.Raise back of vent assembly and slowly maneuver vent assembly away from unit.
4.Remove screws securing smoke eliminator, located inside oven on top of oven cavity.
5.Reverse procedure to reinstall.
Outer Trim Assembly
1.Turn off power to unit.
2.Open oven door and remove screws securing unit to the wall.
3.Slide unit approximately 6 inches out of wall cutout being carefull to not damage control panel.
4.Remove screws securing outer trim assembly to unit.
5.Reverse procedure to reinstall.
©2003 Maytag Appliances Company | 16021875 Rev. 0 | 19 |
