Maytag AOES3030, AOCS3040 manual Adjusting Oven Temperature, Service Tones and Codes

Programming Instructions—ERC for AOES3030

Adjusting Oven Temperature

Oven temperature has been factory calibrated and tested. In unlikely event that oven consistently overcooks or undercooks food, oven temperature can be adjusted.

1.Press BAKE pad.

2.Press + until an oven temperature greater than 500°F shows in display.

3.Immediately press and hold BAKE pad until "00" appears in display, approximately 5 seconds.

4.To decrease oven temperature (for cooler oven), press

-until negative numbers appear. Oven can be adjusted from 05° to 35° lower. To avoid over-adjusting oven move temperature -5° each time.

5.To increase oven temperature (for a warmer oven) press + until positive number’s appear. Oven can be set from 05° to 35° higher. To avoid overadjusting oven, move temperature 5° each time.

6.Press OVEN CANCEL pad. Temperature adjustment will be retained even through a power failure.

Service Tones and Codes

Electronic range control has a self-diagnostic system. Self-diagnostic system sounds a series of short, rapid beeps and shows an “F-code” in display when there is a problem. When electronic range control signals a problem, follow steps listed below.

1.Record “F-code” shown.

•See, DIGIT FAILURE DISPLAY in “ERC Warnings and Failure Codes” section.

2.Disconnect electrical supply.

•Pressing OVEN CANCEL pad or disconnecting electrical supply may eliminate “F-code”. If failure continues, contact an authorized servicer.

3.Contact an authorized servicer to check range.

B—6 16021875 Rev. 0 ©2003 Maytag Appliances Company