General Information
Removing Oven Door
The oven door can be removed for ease in cleaning large spills.
!CAUTION
To avoid personal injury or property damage, handle oven door with care. Door is heavy and can be damaged if dropped.
Do not place hands in hinge area when door is removed. Hinge can snap closed and pinch your hands.
Door contains tempered glass. If glass is scratched, chipped, impacted or twisted it may break suddenly. If door glass appears damaged it should be replaced immediately.
1.Open door to first stop.
2.Remove screws in door liner.
3.Grasp door firmly on each side and lift it upward off hinges. Do not push hinges closed once oven door is removed.
• Do not lift door using door handle.
remove
screw hereremove
screw here
Replacing Oven Door
1.Make sure the hinges are open to the first stop position. If hinges have been accidentally closed, carefully pull them open to first stop. Align door with hinge arms.
2.Slide door down and into place. Be sure door is completely down on hinges.
3.Replace screws in door liner.
Replacing Oven Light
Protective gloves must be worn when changing light bulb.
1.Disconnect electrical supply by turning off power at fuse box.
2.Remove oven door.
3.Remove light cover by inserting a screwdriver, blade end covered in masking tape, into slot at front of lens cover and prying lens cover downward.
4.Unscrew bulb from receptacle.
•Replacement bulbs are available through your local Amana service or parts center.
Tilting Control Panel
Control panel can be adjusted to tilt from 0° to 12° to make more visible.
1.Loosen screws on top, and sides of control panel and pivot screw on bottom, sides of control panel before installing oven, or while oven partially pulled from opening.
2.Adjust control panel to desired angle and retighten screws.
0° tilt
Loosen screw
12° tilt
Pivot screw
8 | 16021875 Rev. 0 | ©2003 Maytag Appliances Company |
