Disassembly Procedures
! | WARNING | To avoid risk of electrical shock, personal injury or death; |
disconnect power to unit before servicing. |
STACK DRYER SLOPED FRONT (PR
RemoveMODEL)
Screws
Note: The following is exclusive to the PR Model -
sloped Front Dryer.
Microprocessor
1. Disconnect power supply to unit.
5.Tip the top of the front panel forward and slightly lift the Front Panel at the same time. Then remove the wires from the door switch.
Tip
Forward
&Lift up Slightly
Note: Display is larger on “PR” model dryers.
2. Remove four security screws securing facia.
3.Remove three screws securing the microprocessor to the Control Console.
4.Remove Control Panel.
5.Disconnect wiring connections.
6.Remove Microprocessor Board and bracket.
6.With the wiring removed from the door switch, continue to tilt the front panel forward while lifting the panel to clear the two lower mounting brackets.
STACK DRYER-MN Models
Note: The following section is exclusive to the MN stack dryers.
©2004 Maytag Appliances Company
Front Panel
1.Disconnect power supply to unit.
2.Remove two front screws.
3.Swing panel out and away from dryer.
16022904 Rev. 0 | 53 |
