Basic Operations
■Remote control unit
QUICK
| ALIGN. |
|
| OPERATE |
|
| HIDE |
|
|
| W |
|
|
|
| SCREEN | FREEZE | COMP | VIDEO |
| S |
|
|
|
DIGITAL ZOOM | PC1 | PC2 | DVI | Y/C |
|
|
|
| |
T/W button | KEYSTONE | T | T | FOCUS |
ZOOM | ZOOM | |||
|
| DIGITAL |
|
|
|
| W | W |
|
PRESET button |
| PRESET |
| MENU |
|
|
|
|
EXIT button
EXITENTER
FREEZE message
FREEZE
FREEZE inhibit message
FREEZE
DIGITAL ZOOM inhibit message
D.ZOOM
FREEZE button
Cursor buttons 5/∞ / 2/3
Displaying a Still Picture (FREEZE)
While projecting an image, a still picture is obtained at any time by using the FREEZE button on the remote control.
When you press the FREEZE button:
“FREEZE” appears on the screen for a few seconds and then the still picture is shown on the screen. Refer to the FREEZE message shown on the left of this page.
* To forcibly clear “FREEZE”, press the EXIT button.
When you press the FREEZE button again.
The original image resumes.
Remote control unit | FREEZE |
Notes |
•During freezing, the picture sent from the signal source is lost.
•If any of the inoperative buttons (“MENU”, “QUICK ALIGN.”, “KEYSTONE”) are pressed while displaying a still picture, “FREEZE” is displayed on the screen.
•This function will not work with some signal sources (UXGA, etc). In this case, the FREEZE inhibit message appears for a few seconds, as shown on the left. To forcibly clear this message, press the EXIT button.
Zooming a Part of the Image
(DIGITAL ZOOM T/W)
A part of the image being projected can be digitally magnified up to four times. When the DIGITAL ZOOM T or W button is pressed, “Digital zoom” appears on the screen together with the level bar and magnifying power (⋅1.0, ⋅1.2, ⋅1.4, ⋅1.6, ⋅2.0, ⋅2.5, ⋅3.2, ⋅4.0). When “15 sec.” is displayed in the menu, “Digital zoom” will appear in approximately 15 seconds.
Digital zoom | 1.2 |
•To zoom up or zoom down, press the DIGITAL ZOOM T or W button on the remote control.
Remote control unit
T
DIGITAL
ZOOM
W
Moving the zoomed image:
While “Digital zoom” appears on the screen, you can move the zoomed image with the cursor (5/∞/2/3) button on the remote control.
5: Upper part of the image will be displayed.
∞: Lower part of the image will be displayed.
2: Left side part of the image will be displayed.
3: Right side part of the image will be displayed.
Notes |
•This function will not work with some signal sources (UXGA, etc). In this case, the DIGITAL ZOOM inhibit message appears for a few seconds, as shown on the left. To forcibly clear this message, press the EXIT button.
•The quality of the zoomed image reduces in comparison with the original one.
•To return to the original size (⋅1.0) and original position, press the PRESET button while “Digital zoom” is displayed on the screen.
36
