Replacing the Fuse
A fuse is used to protect the power source of the projector. If the fuse is blown, replace it. When the power switch is turned on but no power is supplied to the projector, check the fuse. If there are any unclear points, contact the dealer where you purchased your projector, or consult the Service center.
CAUTION |
•When replacing the fuse, use the same rating and type (12 A 250 V). Otherwise, a fire may occur and/or the projector may be damaged.
1Turn off the main power switch and disconnect the power cord from both
the projector and the wall outlet.
In 
] position.
2Loosen the fuse holder to remove it.
To loosen the fuse holder, use a Phillips screwdriver.
3Remove the fuse from the fuse holder you just removed.
4Install the new fuse (not supplied) into the fuse holder.
5Reinstall the fuse holder into the
projector.
To reinstall the fuse holder, use a Phillips screwdriver.
Fuse holder
Phillips screwdriver
Fuse (12 A, 250 V)
Fuse holder
Fuse (12 A, 250 V)
Fuse holder
56
