Meridian Audio FDP-DILA2 Controls and Features, 1Exhaust vents, 2Carrying handle, 4Fuse holder

Controls and Features

Front Side / Top Surface / Right Side

9

1

8
7
Cabinet Design
Subject to Change without notice.	6	5 4 3 2

1Exhaust vents

Vents for cooling fans through which warm air comes out.

CAUTION

•Do not block the exhaust vents, or heat will build up inside, possibly causing a fire. Also, do not touch the vents, or this could give you a low-temperature burn.

2Carrying handle

Raise this handle when carrying the projector.

CAUTIONS

•When carrying the projector, do not transmit shocks to it. Also be careful to keep it balanced.

•Do not carry it while the light-source lamp is on or the cooling fan is operating. This could cause personal injury.

3AC IN (power input) terminal

This is the power input terminal where the supplied power cord is connected. For details, refer to page 30.

4Fuse holder

A fuse rated 12A/250V is installed. (Power source protection)

To replace the fuse, refer to page 57.

CAUTION

•When replacing the fuse, use the same rating and type. Otherwise, a fire may occur and/or the projector may be damaged.

5MAIN POWER switch

6Adjustable feet (for adjusting the height and angle)

By extending the feet, the projector angle can be adjusted up to +7°.

For details, refer to “Adjusting the Inclination of the Projector” on page 16.

7Lens

One of the optional lens units should be installed before using the projector.

A lens-hole blind cover (black one) is installed when the projector is shipped from the factory.

For details on the types of optional lenses available, refer to page 18.

CAUTION

•Please consult your authorized dealer or service center for information about attaching an optional lens.

8Lens cap

This is the lens cap provided for the optional lens.

When you are not using the projector, attach the lens cap to protect the lens from dirt or being damaged. (Refer to page 30.)

9Remote sensor

When operating with the remote control, aim it toward this sensor. (Refer to page 20.)

This is the main power switch. When it is turned on, the projector goes into stand-by state, and the STAND BY indicator on the control panel comes on. (Refer to page 32.)

ON [ ]: The main power turns on.

OFF [‡]: The main power turns off.

6