Meridian Audio FDP-DILA2 warranty Control Panel on the Projector

Controls and Features

Control Panel on the Projector

r			1
e
	LAMP	TEMP	STAND BY	2
			OPERATE
w	HIDE			3
q			PC	4
	KEYSTONE			5
			VIDEO
	PRESET		MENU
p				6
9				7
8	EXIT		ENTER

1STAND BY Indicator

ON : When in stand-by mode. Blinking :When in cool-down mode.

Memo

About the cool-down mode:

This projector has a function to cool down the heated lamp for a fixed period of time (approx. 120 seconds) after projection is finished. This feature is referred to as the cool-down mode. The purpose of the cool-down mode is to prevent inner parts from being deformed or broken by heat from the heated lamp as well as to prolong the life of the lamp.

CAUTIONS

•Do not turn off the MAIN POWER switch while in the cool- down mode.

•Do not place the projector on its side or stand it upright while in the cool-down mode; this may block the vents.

2OPERATE indicator

ON : When the projector is in operation (projecting).

OFF : When the projector is not in operation (not projecting).

3OPERATE button

When the projector is in the stand-by mode, press this button one second or more, and the projector is turned on, causing the OPERATE indicator to light.

Press it one second or more again, and the projector goes into the cool-down mode, then stand-by mode. (Refer to page 32.)

* You cannot use the OPERATE button for about one minute after the lamp blinks. Press the button after a minute or longer has elapsed.

Memo

While in the cool-down mode (STAND BY indicator is blinking):

Even if you press the OPERATE button, the projector is not turned on. Wait until the projector enters stand-by mode (STAND BY indicator stays lit).

4PC button

Use this button to select a device connected to the PC 1, PC 2 or DVI terminals. Each time you press the button, the selection alternates among PC 1, PC 2 and DVI.

* “PC1” , “PC2” or “DVI” will be displayed on the top right of the projected image. (This function can be disabled by the menu.)

5VIDEO button

Use this button to select a device such as a video deck connected to the AV IN (Y/C, VIDEO or COMP) terminal of the projector. Each time you press the button, the selection alternates among Y/C, VIDEO and COMP.

* “Y/C”, “VIDEO” or “COMP” will be displayed on the top right of the projected image. (This function can be disabled by the menu.)

6MENU button

Use this button to enter or exit the menu mode. The main menu appears or disappears at the screen. For details, refer to “Basic Menu Operation” on page 43.

7ENTER button

This button will be used in the menu mode. Use to display the hierarchical menus. Also use when “ENTER” is displayed against the item on the menu screen or when the “All reset” selection is confirmed. For details, refer to “Basic Menu Operation” on page 43.

8Cursor buttons 5/∞/2/3

These buttons will be used in the menu mode to select an item, or to set or adjust the value. For details, refer to “Basic Menu Operation” on page 43.

9