Meridian Audio FDP-DILA2 Insert the new light-sourcelamp fully, inside and fasten the screws

	Replacing the Light-Source Lamp
3 Insert the new light-source lamp fully	Light-source lamp
inside and fasten the screws.

Fasten the two screws with a flat-end screwdriver.

CAUTION

• Do not touch the glass surface of the light-source lamp
directly with your hand as well as staining it. If you touch
with a bare hand, oils and other substances on your hand
may adhere to the lamp, possibly preventing it from
performing as specified and therefore giving a shortened
lamp life, a darkened screen, etc. To handle a new light-
source lamp, hold it by the plastic part. Never touch the	Handle
metal part or the front glass surface.

4Replace the lamp-replacement opening

cover and fasten the screws.

Fasten the two screws with a flat-end screwdriver.

CAUTIONS

Screw

Lamp-replacement opening cover

•Install the light-source lamp and close the lamp- replacement opening cover correctly; otherwise, a safety switch is activated to prevent the projector from operating.

•If the claw on the lamp-replacement opening cover is damaged, the projector may not possibly operate. Then, replace with a new lamp-replacement opening cover.

5Reset the lamp use time.

Perform “Resetting the Lamp Use Time” on page 62.

Be careful not to damage the claw.

60